Kimberly ; 23; Mexican ♥
As practiced in the funeral homes of the Western World (notably North America), embalming uses several steps.The deceased is placed on the mortuary table in the supine anatomical position with the head elevated by a head block. The first step in embalming is to check that the individual is in fact deceased, and then verify the identity of the body (normally via wrist or leg tags). Any clothing on the corpse is removed and set aside and any personal effect such as jewelry is inventoried. A modesty cloth is sometimes placed over the genitalia. The corpse is washed in disinfectant and germicidal solutions. During this process the embalmer bends, flexes and massages the arms and legs to relieve rigor mortis. The eyes are posed using an eye cap that keeps them shut and in the proper expression. The mouth may be closed via suturing with a needle and ligature or using an adhesive. The process of closing the mouth, eyes, shaving, etc. is collectively known as setting the features.
The actual embalming process usually involves four parts:
- Arterial embalming, which involves the injection of embalming chemicals into the blood vessels, usually via the right common carotid artery. Blood and interstitial fluids are displaced by this injection and, along with excess arterial solution, are expelled from the right jugular vein and collectively referred to as drainage. The embalming solution is injected with a centrifugal pump and the embalmer massages the body to break up circulatory clots as to ensure the proper distribution of the embalming fluid. This process of raising vessels with injection and drainage from a solitary location is known as a single-point injection. In cases of poor circulation of the arterial solution additional injection points (commonly the axillary, brachial or femoral arteries, with the ulnar, radial and tibial vessels if necessary) are used. The corresponding veins are commonly also raised and utilized for the purpose of drainage. Cases where more than one vessel is raised are referred to as multiple-point injection, with a reference to the number of vessels raised (i.e. a six-point injection or six-pointer). As a general rule, the more points needing to be raised, the greater the difficulty of the case. An injection utilizing both the left and right carotids is specifically referred to as a restricted cervical injection (RCI), while draining from a different site to injection (i.e. injecting arterial fluid into the right common carotid artery and draining from the right femoral vein) is referred to as a split (or sometimes cut) injection.
- Cavity embalming refers to the replacement of internal fluids inside body cavities with embalming chemicals via the use of an aspirator and trocar. The embalmer makes a small incision just above the navel (two inches superior and two inches to the right) and pushes the trocar in the chest and stomach cavities to puncture the hollow organs and aspirate their contents. He then fills the cavities with concentrated chemicals that contain formaldehyde. The incision is either sutured closed or a “trocar button” is secured into place.
- Hypodermic embalming is a supplemental method which refers to the injection of embalming chemicals into tissue with a hypodermic needle and syringe, which is generally used as needed on a case by case basis to treat areas where arterial fluid has not been successfully distributed during the main arterial injection.
- Surface embalming, another supplemental method, utilises embalming chemical to preserve and restore areas directly on the skin’s surface and other superficial areas as well as areas of damage such as from accident, decomposition, cancerous growth or skin donation.